1976E136 NO CUT

Route All SoftstartRV wires into the electrical box. Then Crimp the connectors on all the SoftstartRV wires as shown in the SoftstartRV box above.
Step 1) Follow the White Compressor wire to the “C” Terminal of the Run Capacitor. Disconnect and then plug it into the Blue SoftstartRV wire.
Step 2) Connect the Black SoftstartRV wire on the Terminal the White Compressor wire was on.
Step 3) Follow the Red Compressor wire to where it connects on the “HERM” Terminal. If there is an empty terminal next to the Red Compressor wire, then connect the Yellow SoftstartRV wire on it. (see Step 4)
Step 4) IF you see a 2nd Red wire next to the Red compressor wire DISCONNECT it, tape the end and drop it. Then connect the Yellow SoftstartRV wire on the Terminal where you pulled off the second Red wire.

NOTE: If you follow your Black Compressor wire and it goes to a connection with a Purple wire then you use steps 5A and 6A. If your Black Compressor wire goes to a Relay then you use Steps 5B and 6B.
Step 5A) Remove the Compressor cap. Disconnect the Black Compressor wire. Crimp a Female disconnect on the Brown SoftstartRV wire and Bend that connector at least 45 degrees. Then connect the newly bent Brown SoftstartRV wire on the terminal where you just pulled off the Black wire.
Step 6A) Crimp a male connector on the Red SoftstartRV wire and connect it to the Black wire you just removed from the compressor. Tape the connection.
Step 5B) Follow the Black Compressor wire to the Start Relay. Disconnect the Black wire and connect it to the Brown SoftstartRV wire.
Step 6B) Connect the Red SoftstartRV wire on the terminal that the Black wire was on.

Replace the compressor cap and secure the wires to prevent the fan from pulling them in during testing. Turn the Power and A/C breakers on. Turn the Fan on high until you hear it running. Then turn the A/C to Auto Cool and set the Thermostat to 55 degrees. Look for the SoftstartRV Green Light. Note: There may be a Full 3 min delay before the Green Light comes on. When the Green Light comes on, turn the power and A/C off, tidy up your wires and replace all the covers. Turn the A/C back on and set the thermostat to about 2 degrees below the outside temperature. Allow it to run for approximately 30 minutes allowing it to cycle a few times.

IF no Green Light comes on after 4 minutes shut the A/C down and contact Tech Support, www.softstartrv.com/support and fill out a ticket.

If You're Not A SoftStartRV Owner Yet, Click The Buy Now Button Below For A Special Offer